Numerical Formulation of Solidification of Aluminum Casting in 2-D Green Sand Mould

Autores

  • Hemant Sharma Department of Mechanical Engineering, Madhav Institute of Technology and Science Gwalior, India

Palavras-chave:

Sand Casting, Mould cavity, Aluminium, Laplace equation

Resumo

Unsteady numerical simulation of steady state and unsteady state conduction heat transfer has been done for solidification of pure Aluminium in green sand mould. As during the solidification heat transfer by conduction will dominate over convection and radiation. Heat conduction equation in two-dimensional Cartesian co-ordinate governs the problem. Convective boundary condition has been considered at the interface of the casting part and mould cavity. Heat conduction equation in unsteady state (Laplace’s) and transient state will be solved using Scilab to study the thermal flow and cooling rate. The pure aluminium and green sand mould will be used as a molten material and mould cavity material respectively.Cite this ArticleHemant Sharma. Numerical Formulation of Solidification of Aluminum Casting in 2-D Green Sand Mould. Trends in Mechanical Engineering & Technology. 2015; 5(3): 38–41p.

Biografia do Autor

  • Hemant Sharma, Department of Mechanical Engineering, Madhav Institute of Technology and Science Gwalior, India
    Mechanical, MTech Student

Downloads

Publicado

2015-12-03

Edição

Vol. 5 N.º 3 (2015)

Secção

Short Articles

Licença

Declaration and Copyright Transfer Form

(to be completed by authors)

 

I/ We, the undersigned author(s) of the submitted manuscript, hereby declare, that the above manuscript which is submitted for publication in the STM Journals(s), is not published already in part or whole (except in the form of abstract) in any journal or magazine for private or public circulation, and, is not under consideration of publication elsewhere.

·         I/We will not withdraw the manuscript after 1 week of submission as I have read the Author Guidelines and will adhere to the guidelines.

·         I/We Author(s ) have niether given nor will give this manuscript elsewhere for publishing after submitting in STM Journal(s).

·         I/ We have read the original version of the manuscript and am/ are responsible for the thought contents embodied in it. The work dealt in the manuscript is my/ our own, and my/ our individual contribution to this work is significant enough to qualify for authorship.

·          I/We also agree to the authorship of the article in the following order:

Author’s name                                    

 

1. ________________

2. ________________

3. ________________

4. _______________

 

We  Author(s) tick this box and would request you to consider it as our signature as we agree to the terms of this Copyright Notice, which will apply to this submission if and when it is published by this journal.